Viking F20481 - Manual (Page 16)

31
7 8
Open doors as wide as possible. Firmly push tube 5/8” into the connector. Use lines on
the tube as a guide for full insertion. NOTE: If water line
tube end is damaged, cut off 5/8” before reconnecting.
If leaking occurs, reconnect the line.
9
Replace toe grille. Align the toe grille mounting clips
with the lower cabinet slots. Push the toe grille firmly
until it snaps into place.
30
1 2
Install hinges with Phillips screws. Place hinge side of refrigerator doors on hinge pins.
3 4
Install top hinges loosely with 5/16” hex head screws. While holding refrigerator doors upright, tighten down
top hinges with 5/16” hex head driver.
5 6
Reconnect two-pin connector. Replace top hinge covers.
Door Reinstallation
(Side-By-Side)