Viking F20481 - Manual (Page 18)

35
1 2
A AAA
Remove toe grille.
Grasp firmly and pull outward to unclip.
Using hex head driver, turn the front adjustment screws
“A” on each side to raise or lower the front of the
refrigerator.
BBB B
3 4
Using the hex head driver, turn each of the adjustment
screws “B” to raise or lower the rear of the refrigerator.
Using the carpenter’s level, make sure front of
refrigerator is 1/4” (.06 cm) or approximately half a
bubble higher than back of refrigerator.
Leveling
(Side-By-Side)
To protect property and refrigerator from damage, observe the following:
• Protect vinyl or other flooring with cardboard, rugs, or other protective material.
• Do not use power tools when performing leveling procedure.
Materials Needed
• 3/8” hex head driver
• Carpenter’s level—To enhance the appearance and maintain performance, the refrigerator should
be level.
• Stabalizing legs are stored in the freezer basket. Install Stabalizing legs by tipping refigerator back
slightly and screwing the legs in clockwise.
NOTE: Complete any required panel installation and/or water supply connection before
leveling. Refrigerator should be in permanent location prior to leveling.
34
1
A
2
Remove toe grill. Grasp firmly and pull outward
to unclip.
To raise the front of the unit, turn the leveler foot
screw clockwise.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveler foot screws.
A
3 4
To lower the front of the unit, turn the leveler foot
screw counterclockwise.
NOTE: It may take several turns of the leveler foot screw
to adjust the tilt of the refrigerator.
Replace toe grill. Align the toe grille mounting clips
with the lower cabinet slots. Push the toe grille firmly
until it snaps into place. Check for level.
Leveling
(Bottom-Mount & French Door Bottom-Mount)
To protect property and refrigerator from damage, observe the following:
• Protect vinyl or other flooring with cardboard, rugs, or other protective material.
• Do not use power tools when performing leveling procedure.
Materials Needed
• 1/4” hex head driver
• Carpenter’s level
To enhance the appearance and maintain performance, the refrigerator should be level.
NOTE: Complete any required panel installation and/or water supply connection before
leveling. Refrigerator should be in permanent location prior to leveling.