Vortex Media VTX 1000 - Manual (Page 17)

"unbalanced". The signal conducting part of the connector is called "tip" and the ground line is called
"shield".
If the input of the amplifier has a balanced input, connect the Positive conductor of the Vortex device to Pin
2 of the XLR connector, the Negative conductor of the Vortex device to Pin 3 of the XLR connector, and the
Shield of the Vortex device to the Pin 1 of the XLR connector. Refer to Cable Drawing 1 in the Vortex
Output Wiring section of the Appendix.
If the input of the amplifier has a unbalanced input, connect the Positive conductor of the Vortex device to
the Tip of the RCA connector and the Negative conductor of the Vortex device to Shield of the RCA
connector. The shield of the cable is not connected at the unbalanced end. Refer to Cable Drawing 2 in the
Vortex Output Wiring section of the Appendix.
I
NTERNAL
A
MPLIFIER
O
VERVIEW
D
RAWING
This drawing illustrates 1 loudspeaker that is connected to the Speaker Output terminals of a Vortex
EF2241.
Refer to the Vortex Internal Amplifier Wiring section of the Appendix for several examples to illustrate
proper and improper loudspeaker configurations.
17