Vortex Media VTX 1000 - Manual (Page 99)

A
PPENDIX
C: V
ORTEX
I
NPUT
W
IRING
C
ABLE
D
RAWING
1: W
IRED
M
ICROPHONE
C
ONNECTION
Connect the Positive conductor of the Vortex device to Pin 2 of the XLR connector, the Negative conductor
of the Vortex device to Pin 3 of the XLR connector, and the Shield of the Vortex device to the Pin 1 of the
XLR connector.
C
ABLE
D
RAWING
2: B
ALANCED
O
UTPUT TO
V
ORTEX
I
NPUT
C
ONNECTION
Connect the Positive conductor of the Vortex device to Pin 2 of the XLR connector, the Negative conductor
of the Vortex device to Pin 3 of the XLR connector, and the Shield of the cable to the only to the Vortex
device.
C
ABLE
D
RAWING
3: U
NBALANCED
O
UTPUT TO
V
ORTEX
I
NPUT
C
ONNECTION
Connect the Positive conductor of the Vortex device to the Tip of the RCA connector and the Negative
conductor of the Vortex device to Shield of the RCA connector. Although the wiring will not affect the gain
structure of the unbalanced output, this type of wiring method will take advantage of the common- mode
rejection characteristics of the balanced input since both the positive and negative pins of the balanced
input are used. The shield of the cable is not connected at the unbalanced end.
99