Vivitar DIGITAL VIDEO RECORDER DVR 943HDv2 - Manual (Page 6)

6
When powering the digital video recorder ON for the first time the digital video recorder will take
you through the initial setup.
Powering the Digital Video Recorder ON
1. Make sure the lithium battery has been charged and inserted properly.
To charge the lithium battery:
- Connect the USB cable (supplied) to camcorder and the other end of the cable either to
your computer USB slot or to the supplied AC Adapter (which you then plug into an electrical
outlet).
- Charge light will turn off when battery is fully charged.
2. Make sure an SD card has been properly inserted into your digital video recorder (inserted
until a click sound is heard).
Note: After the digital video recorder is powered on, an SD icon will appear on the LCD
display. If you do not see the SD icon on the display, please check if the card was
inserted properly.
Important - You must use a Class 4 SD card or higher SD card only. Insert SD
Memory Card (up to 32GB) before use.
Make sure the SD card is not locked (check the lock switch on the side of the SD
card). If the SD card is locked this will prevent the camera from saving captured
photos to the SD card.
3. Flip open the LCD screen and press the POWER button , located on the inside wall, to
turn on the digital video recorder.
Setting the Language
1. You will first be prompted to select a language for the camera. The Language selection
menu will appear. Select the language of your choice and press the OK button to confirm the
selection.
2. After selecting a language, you will be asked if you would like to continue with the initial