VTech LS6325-2 - Manual (Page 2)

2
Headset charger installation
Install the headset charger as shown below.
Headset charger
Plug the small end of the
headset charger power
adapter into the power jack
of the headset charger.
Plug the large end of the
headset charger power
adapter into an electrical
outlet not controlled by a
wall switch.
Power on the headset
Power on the headset before use. Place the headset in the
headset charger or press and hold for two seconds. The
light flashes three times in blue and you hear three beeps
when the headset is being powered on.
Headset charging
Charge the headset as shown below. If the light does not
turn on while charging, you need to charge the headset without
interruption for at least 5 minutes to give the headset enough
charge to use for a short time. For best performance, charge the
headset continuously for at least three hours.
1. Place the tip of
the headset in
the small cradle
on the headset
charger.
2. The magnet holds
the top of the
headset in place.
The light turns
on when charging.
/FIND HaNDSeT
Page all system
handsets and headset.
Message window
Shows the number of
messages and other
answering system
information.
X/DeLeTe
Delete the message currently playing.
Press twice to delete all old
messages when the telephone is not
in use.
/aNS ON/OFF
Turn the
answering
system on or off.
/PLaY/STOP
Play messages.
Stop message playback.
/VOL and
VOL/
Adjust the
volume during
playback.
Adjust the
telephone base
ringer volume
when the
telephone is not
in use.
IN USe light
Flashes when there
is an incoming call,
or another telephone
sharing the same line
is in use.
On when the
telephone is in use,
or the answering
system is answering
a call.
Telephone base overview
/SKIP
Skip to the next message.
/rePeaT
Repeat a message or press
twice to play the previous
message.