D-Link DFL-2500 - Manual (Page 121)

Figure 4.8. Transparent mode scenario 1
Example 4.13. Setting up Transparent Mode - Scenario 1
Web Interface
Configure the interfaces:
1. Go to Interfaces > Ethernet > Edit (wan)
2. Now enter:
• IP Address: 10.0.0.1
• Network: 10.0.0.0/24
• Default Gateway: 10.0.0.1
• Transparent Mode: Enable
3. Click OK
4. Go to Interfaces > Ethernet > Edit (lan)
5. Now enter:
• IP Address: 10.0.0.2
• Network: 10.0.0.0/24
• Transparent Mode: Enable
6. Click OK
Configure the rules:
1. Go to Rules > IP Rules > Add > IPRule
2. Now enter:
• Name: HTTPAllow
• Action: Allow
• Service: http
• Source Interface: lan
4.6.6. Transparent Mode Scenarios Chapter 4. Routing
121