Complete hardware reset to factory defaults, Warning – D-Link DFL-2500 User Manual
Page 46
Example 2.15. Complete Hardware Reset to Factory Defaults
CLI
gw-world:/> reset -unit
Web Interface
1.
Go to Maintenance > Reset
2.
Select Restore the entire unit to factory defaults then confirm and wait for the restore to complete.
Reset alternative for the DFL-210/260/800/860 only
To reset the DFL-210/260/800/860 you must hold down the reset button at the rear panel for 10-15
seconds while powering on the unit. After that, release the reset button and the DFL-210/800 will
continue to load and startup in default mode, that is to say with 192.168.1.1 on the LAN interface.
Reset alternatives for the DFL-1600 and DFL-2500 only
Press any key on the keypad when the "Press keypad to Enter Setup" message appears on the
display. Select "Reset firewall", confirm by selecting "Yes" and wait for the process to complete.
Warning
DO NOT ABORT THE RESET TO FACTORY DEFAULTS PROCESS. If aborted the
D-Link Firewall can cease to function properly.
2.5.3. Resetting to Factory Defaults
Chapter 2. Management and Maintenance
46