VIEWSONIC VS12276-1G - Manual (Page 8)

ViewSonic N2690w 6
Place the TV on a solid surface
1. Ensure that the TV is placed in a position to allow free flow of air. Do not cover the
ventilation openings on the back cover.
2. Leave at least 15cm around the TV set. Otherwise, air-circulation may be
inadequate and cause overheating, which may cause a fire or damage to the TV
set.
3. Never place the TV set in hot, oily humid or excessively dusty places.
4. To prevent any unsafe situations, no naked flame sources, such as lighted candles,
should be placed on or in the vicinity.
5. Avoid heat, direct sunlight and exposure to rain or water. The equipment shall not
be exposed to dripping or splashing.
Install the wall mount plate to the LCD TV
This TV is in compliance with the VESA standards for wall-mounting. Refer to product
specifications for the wall-hanging dimension.
In case of wall-hanging, for your safety and that of the equipment, please use the wall-
hanging bracket in compliance with the specifications of thins machines (see page 20)
and install it under the guidance of the professionals.
If you want to hang your TV set on the wall, all connecting wires must be plugged in the
interfaces of the TV set in advance.
At least 6cm space must be left between the TV set and the wall surface to ensure all
the interfaces have enough room for plugging in.
Wherever you place or hang your TV set, you must ensure the air can be freely
circulated through the ventilation slot.
Do not place the TV set in a closed space.
Connecting the power
Plug one end of the power cord into the port “Power In” on the lower rear of the TV set,
and plug the other into the 220V power outlet.
Avoid placing the LCD TV on any AC power cord. Or, it may cause fire disaster or
electric shock.
If the unit is not turned off and in the standby state, the TV set will always consume a
certain electric power.
When the TV set will not be used for a long period of time, it is recommended to unplug
it from the power outlet.