Westell Technologies Wirespeed 2100 - Manual (Page 9)

030-300198 Rev. D 7 March 2003
WireSpeed Dual Connect NAT Router User Guide
5.4.2 Router Installation via USB
NOTE: The USB installation will not function for Macintosh computers. Macintosh computers must install
the Router via Ethernet connection. See section 5.4.1.
1. Connect the power supply cord to the power connector marked
~
on the rear panel of the Router. Plug the
other end of the power supply cord into a surge-protected AC wall socket.
2. Connect the DSL phone cable from the connector marked on the rear panel of the Router marked to the
DSL-equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You
must use the phone cord that was provided with the Router kit.
3. Connect the USB cable from the USB connector marked on the rear panel of the Router to the USB port
on the PC.
Congratulations! You have completed the USB hardware installation for your Dual Connect NAT Router. Refer to
your Internet service provider’s instructions for installing subscriber software and connecting to the Internet. You
must now go to Section 6 to begin the USB drivers software installation.
Figure 2. Connection via USB
12V
!