Windsor Elevator - Manual (Page 6)

6
OPERATING INSTRUCTIONS
The following must be observed at all times:
• Do not exceed capacity of 500 lbs. (227kg)
• Do not bypass any control sensors.
• Do not lean against scissors car gate.
• Do not use elevator to transport freight.
• Do not operate elevator if it has been damaged.
• In case of fire, do not use elevator.
-LANDING CONTROLS:
To “call” the car to your floor:
Press and release the landing control button. The button will illuminate,
indicating the car is traveling to your floor. The illuminated button will
go off when the car automatically stops at your floor.
If the button does not illuminate when pressed:
a) The car may already be at your floor.
b) The scissors car gate or a hoistway door may not be fully closed.
c) The power may be disconnected from the drive unit.
-CAR CONTROLS:
Upon entering the car, make sure the hoistway door and the scissors car
gate are fully closed. To move the car to the opposite floor:
Press and release the appropriate button (“
UP ” or “ DOWN ”). The car
will begin moving to the opposite floor and automatically stop when it
reaches the floor.
Note: If the landing or car controls are equipped with key switches, only
the key switch at the controls you are using must be turned to the
“
ON ” position (turned clockwise).