Weider Pro 4950 831.14623.0 - Manual (Page 15)

15
21. Apply grease to tw0 M10 x 82mm Bolts (84)
and to the indicated locations on the Leg Press
Frame (123) and the Front Leg Press (132).
Attach the Leg Press (124) to the Leg Press
Frame and the Front Leg Press Frame (123,
132) with the two Bolts (84) and two M10 Nylon
Locknuts (77).
22. Apply grease in the locations shown. Insert a
57mm Spacer (69) into the indicated hole in the
Leg Lever (12). Attach the Leg Lever to the
Front Leg (10) with an M10 x 60mm Bolt Set
(116).
Make sure the barrel of the Bolt Set is
inserted through both sides of the bracket
on the Front Leg. Make sure the indicated
rod is oriented as shown.
See the left inset drawing. Attach the Lock
Plate (14) to the Front Leg (10) with the M8 x
69mm Shoulder Bolt (87), an M8 Washer (103),
and an M8 Nylon Locknut (78).
See the right inset drawing. Insert the Lock
Plate Pin (95) through the Lock Plate (14) and
the Leg Lever (12). Attach the tether on the
Lock Plate Pin to the Front Leg (10) with an M4
x 12mm Self-tapping Screw (102).
23. Orient a Press Arm Handle (17) with the 90°
bend at the top as shown in the inset drawing.
Attach the Press Arm Handle to the Right Press
Arm (16) with two M10 x 65mm Button Bolts
(106), four M10 Washers (80), four 11mm
Spacers (99), and two M10 Nylon Locknuts
(77).
Repeat this step for the Left Press Arm (not
shown).
21
22
12
69
10
116
116
124
132
123
Grease
Grease
77
84
Rod
23
106
106
80
80
80
17
77
16
99
99
99
99
Grease Bracket
Grease
102
103
87
14
10
78
95
10
14
12
90° Bend
17