Weider Pro 4950 831.14623.0 - Manual (Page 8)

8
2. Insert six M8 x 75mm Carriage Bolts (83) up
through the Left Base (119).
Note: It may be
helpful to place a piece of tape over each
Bolt head to hold it in place.
2
3
119
83
83
83
1
78
78
119
103
103
100
1
3. Attach the Right Base (1) to the Left Base (119)
with two M8 x 80mm Bolts (100), two M8
Washers (103), and two M8 Nylon Locknuts
(78).
Do not Tighten the Nylon Locknuts yet.
1.
Insert four M8 x 75mm Carriage Bolts (83) up
through the Right Base (1).
Note: It may be
helpful to place a piece of tape over each
Bolt head to hold it in place.
Apply a portion of the included grease to an
M10 x 141mm Bolt (141). Attach the Foot Plate
(146) to the Right Base (1) with the Bolt and an
M10 Nylon Locknut (77).
Do not overtighten
the Locknut, the Foot Plate must pivot
freely.
Before beginning assembly, make sure
you understand the information in the
box on page 7. See the PART IDENTIFI-
CATION CHARTS on pages 5 and 6 for
help identifying small parts.
Frame Assembly
83
77
141
Grease
146
83
1
4. Attach the Bottom Center Base (147) to the
Right and Left Bases (1, 119) with four M8 x
80mm Bolts (100), four M8 Washers (103), and
four M8 Nylon Locknuts (78).
Do not Tighten
the Nylon Locknuts yet.
4
100
100
103
103
103
103
78
1
147
119