weber 4000 - Manual (Page 12)

12
Step 4
Continue frame assembly
You will need: frame assembly, wheel frame assembly,
front panel, caster frame, four 1/4-20 x 1/2 inch bolts,
four nylon washers and a 7/16 inch wrench.
Place the caster frame onto the tabs of the left frame
with the dimple to the inside. Figure 3. Place the wheel
frame onto the tabs of the right frame with the dimple to
the inside. Figure 3.
The leg tabs must be on the inside of the frames.
Add front panel with the hole down and to your right.
Add the washers to the bolts, insert in the holes as
shown. Only start the bolts at the wheel frame,
figure 3 (a) & (b), and tighten the bolts at the
caster frame.
Dimples to
the inside
Only start
this bolt
Wheel frame
Caster frame
Figure 3
(a)
(b)
Step 5
Complete frame assembly
You will need: partial frame assembly, two frame
connectors, four 1/4-20 x 2 inch bolts, four nylon
washers and a 7/16 inch wrench.
Hold one frame connector between the caster and
wheel frame. Add nylon washers to the bolts. Put the
bolts through the frame and screw into frame connector.
Tighten.
Repeat procedure with the other frame connector.
Figure 4.
Figure 4
Step 6
Insert casters
You will need: frame assembly and two casters.
Push the casters firmly into the inserts in the ends of the
caster legs. Figure 5.
Figure 5