Manual lighting, To extinguish, Ƽ danger ƽ – weber 4000 User Manual

Page 26

Advertising
background image

26

5) Strike a match and put the flame into the matchlight

hole in the front of the cooking box.

6) Push down and hold the FlameCheck button down.

Note - Gas is supplied to the burner only when the
FlameCheck button is depressed.

7) Check that the burner is lit by looking through the

matchlight hole on the front of the cooking box.

If the burner is lit, continue to hold the FlameCheck
button down for about 8 seconds. When the button
is released the burner will stay lit.

ƽWARNING: If the burner does not light, turn the
Front burner control knob to OFF and wait 5 minutes
to let the gas clear before you try again or try to light
with a match.

8) After the FRONT burner is lit you can turn on the

other burners.

Note - The Front burner must be on at all times when
operating the Center or Back burners. The FlameCheck
Safety System monitors the Front burner. For your
safety, the FlameCheck valve will shut off the gas to the
burners if the front burner should inadvertently go out
during cooking.

To Extinguish

Turn gas supply OFF at the source, then push down
and turn each burner control knob clockwise to OFF.

Manual Lighting

1) Open the lid. Figure 2.

2) Make sure all burner control knobs are turned OFF.

(Push each knob down and turn clockwise.)

3) Turn gas supply valve on.

4) Push Front burner control knob down and turn to

START / HI.

ƽWARNING: Do not lean over open barbecue. Keep
your face and body at least one foot away from the
matchlight hole when lighting the barbecue.

5 7

1

2

3

4

6

8

Figure 2

Manual Lighting

ƽ DANGER ƽ

Failure to open lid while igniting the

barbecue, or not waiting 5 minutes to
allow the gas to clear if the barbecue does
not light, may result in an explosive flame-
up which can cause serious bodily injury
or death.

Advertising