weber 4000 - Manual (Page 16)

16
Step 13
Install side burner
You will need: side burner assembly, burner grate,
3/4 inch, 5/8 inch and an 11/16 inch or two adjustable
wrenches.
ƽCAUTION: No sealant is required on the side
burner fitting. Do not use pipe dope, tape or any
other type of sealant on the fittings or hose.
Use an 11/16 wrench to remove the protective brass cap
from the side burner fitting on the manifold. Figure 14.
ƽCAUTION: When removing the cap use a 5/8 inch
wrench to "hold" the side burner fitting to keep it
from becoming loose. If the side burner fitting
should loosen, tighten before attaching side burner
hose.
Slide the side burner assembly into the open end of the
right frame. Route the side burner hose so that it
parallels the front of the barbecue. Loop the hose so
that it reaches the side burner fitting. Attach hose and
tighten with a 3/4 inch wrench. Figure 15. Install burner
grate. Check to be sure the side burner valve is OFF.
Push side burner control knob down and turn clockwise.
Figure 14
Figure 15
Step 14
Install manifold bracket
You will need: manifold bracket
Hook the bracket onto the manifold at the center burner
valve. Figure 16. Place your hand underneath the
bracket. Lift the bracket, manifold and cooking box
slightly as a unit and hook onto the frame brace.
Figure 16
Frame brace
Cap
Side burner fitting
Manifold bracket