White 950-959 - Manual (Page 15)

15
Note:For some operators, the drive clutch handle may not be in a comfortable position. You can adjust the handle
by tightening or loosening the adjustment wheel.
SHIFT LEVER CABLE ADJUSTMENT
Periodic adjustment of the six-speed shift cable may be required due to normal wear on the cable. Adjustment is
needed if all six speeds do not work.
The adjustable cable bracket is located beside the engine on the left side of the mower. Follow steps 1 through 7
to adjust the shift lever
.
SECTION 10: MAINTENANCE
WARNING: Be sure to disconnect and ground the spark plug wire before performing any repairs or
maintenance.
NOTE: When tipping the unit, empty the fuel tank and keep the engine spark plug side up. Never tip the mower
more than 90 degrees and do not leave the mower tipped for any length of time. Oil can drain into the upper part
of the engine causing a starting problem.
ENGINE
Refer to the separate engine manual for all engine maintenance instructions.
• Maintain engine oil as instructed in the separate engine manual packed with your unit. Read and follow
instructions carefully.
• Service air cleaner every 25 hours under normal conditions. Clean every few hours under extremely dusty
conditions. Poor engine performance and flooding usually indicates that the air cleaner should be serviced.
To service the air cleaner, refer to the engine manual packed with your unit.
• The spark plug should be cleaned and the gap reset once a season. Spark plug replacement is
recommended at the start of each mowing season; check engine manual for correct plug type and gap
specifications.
• Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to
permit proper air circulation which is essential to engine performance and life. Be certain to remove all
grass, dirt and combustible debris from the muffler area.
Step 1. Start engine.
Step 2. Place speed control in the sixth speed
position.
Step 3. Stop engine.
Step 4. Disconnect spark plug wire and ground it.
Step 5. Loosen hex nut (A) which secures the
adjustable cable bracket.
Step 6. Push back on the adjustable cable
bracket.
Step 7. Tighten hex nut (A).
Bottom View
Speed Control
Lever
Hex Nut (A)
Adjustable Cable Bracket
PUSH