White 950-959 - Manual (Page 20)

20
SECTION 11: LUBRICATION
WARNING: Always stop engine and disconnect spark plug wire before cleaning, lubricating or doing
any kind of work on the lawn mower.
Figure 11
Step 21. Pinch belt together so that it is not in the
pulley groove, and the lower pulley can be
pushed towards the engine.
Step 22. Pivot the control arm back to its original
position and reinstall the six-speed cable into the
slot.
Step 23. Check and make sure the belt is routed
inside the pulley halves and the belt guard pin.
Step 24. Reinstall the bolt securing transmission to rear mower housing.
Step 25. Pivot the baffle back to its original position and secure with three hex screws earlier removed. You
will need a 3/8” socket for these screws.
Step 26. Lightly lubricate the inside of the blade adapter and reinstall spacer, wave washer, blade adapter
assembly and the blade in the correct order.
Step 27. Tighten the hex bolt to secure the blade. Follow recommended torque which is 450-600 in. lbs.
Belt
Lower Pulley
Belt
Guard
Pin
Half
SEE ENGINE MANUAL
LUBRICATE
Wheels
Caster Assembly
Blade Control
Handle