White 950-959 - Manual (Page 18)

18
DRIVE BELT REMOVAL AND REPLACEMENT
Step 1. Disconnect the spark plug wire and ground it
against the engine.
Step 2. Drain the fuel tank or place a piece of plastic
beneath the cap to prevent gasoline leakage.
Step 3. Place shift lever in the first position.
Step 4. Tip the mower on its side. Block securely.
Step 5. Remove the center bolt which secures the
blade to the crankshaft. Remove the blade, and
the blade adapter, wave washer, and spacer.
Refer to Cutting Blade Removal, Replacement
and Sharpening in the Maintenance Section.
Step 6. Move rear height adjuster to the sixth
position.
Step 7. Remove the hex bolt holding the transmission
to the mower housing.
Step 8. Using a 3/8” socket, remove three hex
screws holding the baffle to the deck.
Step 9. Tilt the transmission forward and loosen the
idler pulley bolt and locknut 1/2 turn using two
7/16” wrenches.
Step 10. Using a pair of pliers, pull back and rotate
belt keeper bracket from the slot on idler pulley.
Step 11. Slide the belt out from between the Belt
Keeper Bracket and the idler pulley.
Step 12. Pivot baffle towards the rear of the mower.
Rear Height Adjustment Lever
Baffle
Hex Bolt
Hex Screw
Hex Screw Hex
Screw
Transmission
Belt Keeper
Bracket
Idler Pulley
Belt
Idler Pulley
Bracket
Transmission
Pulley
Bolt and
Locknut
Baffle