White 950-959 - Manual (Page 16)

16
DECK
The underside of the mower deck should be cleaned after each use to prevent a build-up of grass clippings,
leaves, dirt or other matter. If this debris is allowed to accumulate, it will invite rust and corrosion, and may prevent
proper mulching, discharge or bagging.
The deck may be cleaned by tilting the mower and scraping clean with a suitable tool (make certain the spark plug
wire is disconnected before starting to clean).
ELECTRIC START UNITS ONLY:
BATTERY PACK REPLACEMENT
Remove the battery pack from the handle panel for replacement only. Do not separate the batteries for any
reason. Dispose of batteries properly.
Warning: Batteries contain sulfuric acid which may cause burns. Do not short circuit or mutilate
batteries in any way. Do not put batteries in fire as these may burst or release toxic materials.
When replacing battery pack in handle panel, battery pack must be positioned with the positive terminal to the
right hand side and the negative terminal to the left hand side of panel. Replacing the battery pack incorrectly will
cause serious damage. The positive lead on the wire harness has the smaller connector. Connect the positive
lead to the positive side of the battery pack, then connect the negative side.
In-line Fuse: The unit is equipped with an in-line fuse. If the unit fails to start, check the fuse inside the battery
cover by turning the end of the fuse holder and removing from the battery cover. Replace with standard
automotive 7-1/2 amp fuse.
STORAGE OF THE BATTERY
The battery must be stored with a full charge. A discharged battery will freeze.
IMPORTANT: All batteries discharge during storage. Recharge battery every two months and before returning
to service. Refer to charging instructions in OPERATION section.
CUTTING BLADE REMOVAL, REPLACEMENT AND SHARPENING
Figure 10
• When removing the cutting blade for sharpening or replacement, protect your hands by using heavy gloves
or a rag to handle the blade.
• Remove the bolt and the blade bell support which hold the blade and the adapter to the engine crankshaft.
• Remove the blade and the adapter from the crankshaft.
Warning: Periodically inspect the blade adapter for cracks, especially if you strike a foreign object.
Replace when necessary.
Blade
Hex Bolt
Blade Bell
Adapter
Support