Weider WESY19002 - Manual (Page 14)

26
23
24
25
23. Locate the Long Cable (69). Route the Long
Cable between the Base (4) and the Press
Frame (17) as shown. Lay the Long Cable in
the bracket on the Base.
Attach the Pro-Pulley (77) to the bracket
using a 3/8” x 2” Bolt (12) and a 3/8” Nylon
Locknut (21). Do not overtighten the Nylon
Locknut; the Pulley must be able to turn
freely.
24. Hold the Long Cable (69) against a 3 1/2”
Pulley (15). Hold a Cable Trap (66) against
the Pulley to hold the Cable in place.
Attach the 3 1/2” Pulley (15) and the Cable
Trap (66) to the Front Upright (42) using a
3/8” x 4 1/4” Bolt (64), a 3/8” Washer (9), and
a 3/8” Nylon Locknut (21). Do not overtight-
en the Nylon Locknut; the Pulley must be
able to turn freely.
25. Remove the pre-assembled 3 1/2” Pulleys
(15) from the Pulley Plates (58). Route the
Short Cable (23) around one of the Pulleys.
Reattach a Pulley Plate to each side of the
Pulley with a 3/8” x 2” Bolt (12) and a 3/8”
Nylon Locknut (21). Do not tighten the
Nylon Locknut yet.
Route the Long Cable (69) around the other
3 1/2” Pulley (15). Attach the Pulley to the
bottom set of holes in the Pulley Plates (58)
with a 3/8” x 2” Bolt (12) and a 3/8” Nylon
Locknut (21). Do not overtighten the Nylon
Locknuts; the Pulleys must be able to turn
freely.
26. Route the Long Cable (69) around a 3 1/2”
Pulley (15) as shown. Hold a Cable Trap (66)
against the Pulley so that the Cable is held
securely in the groove.
Attach the 3 1/2” Pulley (15) and the Cable
Trap (66) to the Front Upright (42) using a
3/8” x 4 1/4” Bolt (64), a 3/8” Washer (9), and
a 3/8” Nylon Locknut (21). Do not overtight-
en the Nylon Locknut; the Pulley must be
able to turn freely.
14
CABLE ASSEMBL
Y
69
12
77
21
Bracket
17
4
21
58
21 42
66
69
64
9
69
21
42
9
15
15
23
12
58
69
66
64
15