Weider WESY19002 - Manual (Page 15)

27. Route the Long Cable (69) behind the Press
Frame (17) and under the Seat Frame (36) as
shown. Route the Long Cable around two
3 1/2” Pulleys (15).
Slide the 3/8” x 5” Bolt (75) through the 3 1/2”
Pulleys (15), two Cable Traps (66), and the
Press Frame (17) as shown. Tighten a 3/8”
Nylon Locknut (21) onto the Bolt. Do not
overtighten the Nylon Locknut; the Pulleys
must be able to pivot freely.
28. Locate the section of the Long Cable (69)
between the two 3 1/2” Pulleys (15) attached
in step 27. Route this section of the Long
Cable around a “V”-Pulley (6). Hold a Long
Cable Trap (50) against the Pulley to keep the
Cable in the groove of the Pulley.
Attach the “V”-Pulley (6) and the Long Cable
Trap (50) to the second hole from the front of
the Seat Frame (36) using a 3/8” x 3 1/4” Bolt
(8), a 3/8” Washer (9), and a 3/8” Nylon
Locknut (21). Do not overtighten the Nylon
Locknut; the Pulley must be able to turn
freely.
29. Route the Long Cable (69) around a 3 1/2”
Pulley (15). Hold a Cable Trap (66) against
the Pulley to hold the Long Cable in place.
Attach the 3 1/2” Pulley (15) and the Cable
Trap (66) to the Front Upright (42) using a
3/8” x 4 1/4” Bolt (64), a 3/8” Washer (9), and
a 3/8” Nylon Locknut (21). Do not overtight-
en the Nylon Locknut; the Pulley must be
able to turn freely.
30. Attach the end of the Long Cable (69) to the
Leg Lever (29) using a 5/16” x 2 3/4”
Shoulder Bolt (85), a 5/8” x 1/2” Spacer (82),
two 5/16” SAE Washers (88), and a 5/16”
Jamnut (87).
15
28
69
15
66
21
42
9
64
29
30
CABLE ASSEMBL
Y
36
15
69
6
50
8
9
21
27
75 36
15
66
17
69
15
21
29
88
87
85
82
69
88