Wayne-Dalton TORQUEMASTER 9800 User Manual
Page 17
Tools Needed:
17
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at
www.wayne-dalton.com
INST
ALLA
TION
OPERaTOR
bRaCkET
u-baR
OPERaTOR bRaCkET IN
PlaCE uNDER u-baR
(6) 1/4” - 20 x 5/8”
sElF-DRIllING
sCREWs
TOP sECTION
OPERaTOR
bRaCkET
u-baR
1/4” - 20 x 7/8”
sElF-DRIllING sCREWs
sIDE VIEW OF u-baR ON TOP
sECTION
u-baR
11
Power Drill
7/16” socket
Driver
Operator Bracket
NOTE: If installing a trolley type
operator, complete this step. If not, skip
this step and continue with step 12.
IMPORTANT: WhEN CONNECTING a
TROllEy TyPE GaRaGE DOOR OPENER
TO ThIs DOOR, a WayNE-DalTON
OPENER / TROllEy bRaCkET MusT
bE sECuREly aTTaChED TO ThE TOP
sECTION OF ThE DOOR, alONG WITh
aNy u-baRs PROVIDED WITh ThE
DOOR. ThE INsTallaTION OF ThE
OPENER MusT bE aCCORDING TO
MaNuFaCTuRER’s INsTRuCTIONs aND
FORCE sETTINGs MusT bE aDjusTED
PROPERly.
Remove, but retain (4 - 6) 1/4” - 20 x
7/8” self-drilling screws from the center
of the u-bar, allowing the operator
bracket to slide between the top section
and the u-bar.
NOTE: For retro fit applications, the
operator bracket must be aligned with
an existing operator
locate the center of the top section and
slide operator bracket under u-bar till
the operator bracket is seated against
the u-bar flange. attach the operator
bracket using (6) 1/4” - 20 x 5/8”
self-drilling screws (as shown). Finish
re-attaching the u-bar using the self-
tapping screws removed previously.
TOP sECTION
TOP sECTION