Wayne-Dalton TORQUEMASTER 9800 - Manual (Page 19)

Tools Needed:
19
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
INST
ALLA
TION
Attaching horizontal Track
to quick Install flagangle
NOTE: If you have fully adjustable
flagangle, skip this step and complete
step 14.
To install horizontal track, place the
curved end over the top roller. align
key slot of the horizontal track with the
quick install tab of the flagangle. Push
curved portion of horizontal track down
to lock in place. level the horizontal
track assembly and bolt the horizontal
angle to the slot in the flagangle using
(1) 3/8” - 16 x 3/4” truss head bolt
and (1) 3/8” - 16 hex nut. Repeat for
other side. Remove the nail that was
temporarily holding the top section in
place, installed in step 12.
IMPORTANT: FaIluRE TO REMOVE NaIl
bEFORE aTTEMPTING TO RaIsE DOOR
COulD CausE PERMaNENT DaMaGE
TO TOP sECTION.
DO NOT RaIsE DOOR uNTIl
hORIzONTal TRaCks aRE sE CuRED
aT REaR, as OuTlINED IN sTEP 26, OR
DOOR COulD Fall FROM OVERhEaD
POsI TION CausING sEVERE OR FaTal
INjuRy.
NOTE: If an idrive ® opener will be
installed, position horizontal tracks
slightly above level.
kEy
slOT
quICk
INsTall
Tab
hORIzONTal
TRaCk
VERTICal
TRaCk
Fla
Ga
NG
lE
13
wARNINg
9/16” socket
Ratchet Wrench
9/16” Wrench
level
kEy slOT
quICk
INsTall
Tab
hORIzONTal
TRaCk
VERTICal
TRaCk
Fla
Ga
NG
lE
3/8” - 16 x 3/4”
TRuss hEaD bOlT
3/8” - 16 hEx NuT
hORIzONTal TRaCk
hORIzONTal aNGlE