Wayne-Dalton TORQUEMASTER 9800 - Manual (Page 21)

21
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
TorqueMaster ® Spring Tube
TorqueMaster ® springs come lubricated
and pre-assembled inside the
TorqueMaster
® spring tube. To install, lay
the TorqueMaster ® spring tube on the
floor (inside garage) in front of the door
with the labeled end to the left.
labElED END
TORquEMasTER ®
sPRING TubE
None
16
17
Center Bracket Bushing
NOTE: If you are installing the idrive ®
opener with your garage door, skip this
step and go to your
idrive ® Installation
Instruction/Owner’s Manual. after
completing steps 1 thru 10 in your
idrive ® Installation Instruction/Owner’s
Manual, continue with step 22 of the
door Installation Instruction/Owner’s
Manual.
NOTE: If you are not installing an idrive ®
opener with your garage door, you
must install the center bracket bushing
assembly. Continue to follow these
instructions for non-
idrive ® operated
garage doors.
being cam shaped the center bracket
bushing only fits one way.
slide the center bracket assembly
towards the center of the TorqueMaster
®
spring tube, from the right side as
shown.
CENTER
bRaCkET
assEMbly
TORquEMasTER ®
sPRING TubE
TORquEMasTER ®
sPRING TubE
CENTER
bRaCkET
bushING
None
INST
ALLA
TION
INST
ALLA
TION