Weider 831.159290 - Manual (Page 10)

10
13. Attach the Leg Press Plate (11) to the
Adjustment Tube (10) with a 5/16” x 2 1/2”
Bolt (39), two 5/16” Washers (20) and a 5/16”
Nylon Locknut (40). Be sure that the Leg
Press Plate and Adjustment Tube are ori-
ented as shown.
Press a 1 3/4” Square Inner Cap (48) into the
Adjustment Tube (10).
14. Attach the Adjustment Tube (10) to the Leg
Press Arm (9) with the Small Lock Pin (73).
Be sure the Leg Press Plate (11) is orient-
ed as shown.
Press two 2” Square Inner Caps (56) into the
Leg Press Arm (9).
15. Locate and open the parts bag labeled
“ARM ASSEMBLY.”
Attach the Large Bumper (53) to the Front
Seat Frame (8) with the #10 x 1” Tap Screw
(100).
Lubricate the 3/8” x 3 1/4” Bolt (71). Attach
the Leg Press Arm (9) to the Press Base (13)
with the Bolt and a 3/8” Nylon Locknut (42).
16. Press a 1” x 7/8” Plastic Bushing (54) onto
each welded spacer on the Press Frame (12).
Slide the Press Frame onto the Press Base
(13) so that the Plastic Bushings are aligned
with the indicated tube. Note: This will be a
tight fit. Make sure that the higher hole is
on the side shown.
Lubricate the 3/8” x 8” Bolt (52). Attach the
Press Frame (12) to the Press Base (13) with
the Bolt and a 3/8” Nylon Locknut (42).
ARM ASSEMBL
Y
FRAME ASSEMBL
Y
20
40
39
Angle
10
48
11
56
42
71—Lubricate
53
100
13
54
42
12
13
11
9
9
8
10
73
52—Lubricate
Tube
Welded
Spacers
Higher
Hole
16
13
14
15