Weider 831.159290 - Manual (Page 22)

52. Wrap the Press Cable (88) around a “V”
Pulley (81). Attach the “V” Pulley to the upper
bracket on the Leg Press Upright (4) with a
3/8” x 2” Bolt (50) and a 3/8” Nylon Jam Nut
(43).
53. Wrap the Press Cable (88) around a 3 1/2”
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the indicated hole in the Press
Frame (12) with a 3/8” x 3 1/2” Bolt (66), a
3/8” Washer (38) and a 3/8” Nylon Locknut
(42). Be sure that the Cable Trap is turned
to hold the Cable in place and that the
Cable is between the Pulley and the cross-
bar on the Press Frame.
54. Wrap the Press Cable (88) around a “V”
Pulley (81). Attach the “V” Pulley to the lower
bracket on the Leg Press Upright (4) with a
3/8” x 2” Bolt (50) and a 3/8” Nylon Jam Nut
(43).
55. Wrap the Press Cable (88) around a 3 1/2”
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the Leg Press Arm (9) with the
3/8” x 4 1/2” Bolt (74).
Slide another 3 1/2” Pulley (82) with a Cable
Trap (80) onto the 3/8” x 4 1/2” Bolt (74).
Hand tighten a 3/8” Nylon Jam Nut (43) onto
the Bolt. Do not fully tighten the Nylon
Locknut until step 57.
55
52
53
54
22
CABLE
ASSEMBL
Y
88
81
4
50
43
88
42
80
12
Crossbar
82
38
66
43 82
82
9
80
80
74
88
88
81
4
50
43