Weider 831.159290 - Manual (Page 16)

33. Attach the High Cable (86) to a Small “U”
Bracket (32) with a 1/4” Nylon Locknut (44)
and a 1/4” Washer (37). Do not completely
tighten the Nylon Locknut. It should be
threaded onto the end of the Cable so only
a couple of threads are showing above the
Nylon Locknut, as shown in the inset
drawing.
Attach the Small “U” Bracket (32) to the indi-
cated Weight Tube (25) with a 5/16” x 1 3/4”
Bolt (68) and a 5/16” Nylon Locknut (40).
34. Locate the Rear Cable (87)—this is again
the shortest remaining Cable. Wrap the
Rear Cable around a 3 1/2” Pulley (82).
Attach the Pulley and two Pulley Covers (62)
to the Ab Upright (1) with a 3/8” x 4” Bolt (76),
two 3/8” Washers (38) and a 3/8” Nylon
Locknut (42). Do not overtighten the Nylon
Locknut; the Pulley should turn easily.
Make sure that the Cable is between the
Pulley and the post, and that the Pulley
Covers are turned so the wide tabs are on
the indicated side.
35. Wrap the Rear Cable (87) around a 3 1/2”
Pulley (82). Attach the Pulley and two Pulley
Covers (62) to the Ab Upright (1) with a 3/8” x
4” Bolt (76), two 3/8” Washers (38) and a 3/8”
Nylon Locknut (42). Do not overtighten the
Nylon Locknut; the Pulley should turn eas-
ily. Make sure that the Cable is between
the Pulley and the post.
35
33
34
16
CABLE
ASSEMBL
Y
Post
1
62
Wide Tabs
must be
on this
side
38
82
32
68
86
40
37
44
25
86
44
32
37
42
82 38
38
76
1
87
38
42
76
87
62