Whistler WGPX-635 - Manual (Page 12)

12
Whistler WGPX-635/650
Using the Main Power Switch
When the GPS unit is shipped from the factory or when the unit is stored for long period of time,
the main power switch should be in the “off” position.
When the position is changed to “on” the touch screen calibration screen is displayed. Follow the
instructions on the screen until completed.
Charging the Battery - In Home
Before using the GPS for the first time, we strongly suggest you fully charge the battery. Before
the unit can be charged it must first be manually turned on. See Figure 12A. This switch connects
the battery.
Assemble the AC adapter:
The AC adapter needs to be assembled prior to
use. Follow the diagram in figure 12C to insert
the plug section to the main adapter body.
Main Power - Battery Charging
Figure 12A
Turn the main power switch to the ON
position.
Note: Make sure that the HOLD switch is in
the “unlock” position before use! See page 11,
bottom view, for hold switch location.
Figure 12C
Figure 12B
When the calibration is done successfully tap the
screen to complete the calibration then the unit will
start to load the map program. Follow the on screen
instructions and warnings to begin using the unit for
travel.
Note: The calibration screen will only appear when
the main power switch is changed from “off” to
“on”. If the touch screen appears not to function,
make sure that the HOLD button is in the “unlock”
position.