Whistler WGPX-635 - Manual (Page 20)

20
Whistler WGPX-635/650
Using the Remote Control - Continued
Replacing the Remote Battery
The remote control is powered by a 3 volt coin cell battery, model CR 2025.
To replace the battery, follow these steps:
1. Slide the locking tab to the right.
2. While holding the tab to the right, carefully slide out the battery tray.
3. The battery should slide out from its holder. Make note of the correct polarity. Positive (+)
side of the battery is on the same side of the battery tray that has the “+” marking.
4. Insert the new battery, being mindful of the correct polarity.
5. Slide the battery tray back into the remote.
1
Pull battery tray out
to remove battery.
2
3
Figure 20A
Figure 20B
Operation