Weider PRO POWER STACK 831.159831 - Manual (Page 16)

16
34. Wrap the Ab Cable (74) around a 3 1/2” Pulley
(35) in the direction shown. Attach the Pulley to
the Double “U”-Bracket (31) with a 3/8” x 1 3/4”
Bolt (94) and a 3/8” Nylon Locknut (90).
33. Remove the 3 1/2” Pulleys (35) from the other
pair of pre-assembled Pulley Plates (32).
Wrap the Ab Cable (74) around a 3 1/2” Pulley
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the top hole in the pair of
Pulley Plates (32) with a 3/8” x 2” Bolt (93) and a
3/8” Nylon Locknut (90). Make sure the Cable
Trap is positioned to hold the Cable in the
groove of the Pulley.
33
74
38
90
90
31
35
74
94
35. Wrap the Ab Cable (74) around a 3 1/2” Pulley
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the indicated bracket on the
Butterfly Base (1) with a 3/8” x 2” Bolt (93) and a
3/8” Nylon Locknut (90). Make sure the Cable
Trap is positioned to hold the Cable in the
groove of the Pulley.
36. Wrap the Ab Cable (74) around a 3 1/2” Pulley
(35) in the direction shown. Slide a Cable Trap
(38) and the Pulley onto the 3/8” x 3 1/2” Carriage
Bolt (95) in the Butterfly Base (1). Secure the
Pulley with a 3/8” Nylon Jamnut (92). Make sure
the Cable Trap is positioned to hold the Cable
in the groove of the Pulley.
32
35
35
36
38
74
35
92
1 95
34
35
93
74
90
38
1
93
32