Weider PRO POWER STACK 831.159831 - Manual (Page 29)

29
97
12
72
104
34
90
97
5 72
85
34
90
37
Slack can be removed from the Press Cable (72) by
moving the “V”-Pulley (34) attached to the Press Seat
Frame (12) closer to the Press Upright (5).
Remove the 3/8” x 4 1/4” Bolt (85), 3/8” Washer (97),
and 3/8” Nylon Locknut (90) from the Press Seat
Frame (12), the “V”-Pulley (34), and the Long Cable
Trap (37). Move the Pulley to a hole that is closer to
the Press Upright (5), one hole at a time, until the
slack is removed. Reattach the Pulley and Cable Trap
to the hole with the Bolt, Washer, and Nylon Locknut.
If there is still slack in the Press Cable (72), move the
“V”-Pulley (34) attached to the small tube on the
Press Upright (5) to a hole that is closer to the
Upright.
Remove the 3/8” x 3 1/4” Bolt (104), 3/8” Washer
(97), and 3/8” Nylon Locknut (90) from the Press
Upright (5), the “V”-Pulley (34), and the Long Cable
Trap (37). Move the Pulley to a hole that is closer to
the Press Upright, one hole at a time, until the slack
is removed. Reattach the Pulley and Cable Trap to
the hole with the Bolt, Washer, and Nylon Locknut.
If a cable slips off the pulleys often, the cable may have become twisted. Remove the cable and re-install
it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.