Weider PRO POWER STACK 831.159831 - Manual (Page 19)

19
45. Remove the 3/8” Nylon Jamnut (92) from the
3/8” x 4 3/4” Bolt (102) inserted into the Butterfly
Upright (4) in step 43.
Wrap the Low Cable (71) around a 3 1/2” Pulley
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the 3/8” x 4 3/4” Bolt (102)
with the 3/8” Nylon Jamnut (92). Make sure the
Cable Trap is positioned to hold the Cable in
the groove of the Pulley.
46. Attach the Low Cable (71) to the Leg Lever (13)
with a 5/16” x 2 3/4” Shoulder Bolt (108), a 5/16”
Washer (100), and a 5/16” Nylon Jamnut (77).
45
92
71
102
4
35
38
46
100
108
77
13
71
47. Remove a Pro Pulley (110) from the bag
labeled “PULLEY BAG 2.”
Identify the Press Cable (72). It is approximately
387 5/8” long and it has a ball on one end and a
threaded shaft on the other.
Wrap the Press Cable (72) around the Pro Pulley
(110) in the direction shown. Attach the Pulley to
the Press Top Frame (9) with a 3/8” x 3 1/2” Bolt
(111), a 3/8” Washer (97), and a 3/8” Nylon
Jamnut (92). Make sure the Cable is between
the Pulley and the pin on the Press Top
Frame.
47
110
111
72
92
Pin
97
9
48. Route the threaded end of the Press Cable (72)
around the 3 1/2” Pulley (35) that was attached to
the Press Top Frame (9) in step 16. Make sure
the Cable Trap (38) is positioned to hold the
Cable in the groove of the Pulley. Properly
tighten the 3/8” Nylon Locknut (not shown)
attached to the 3/8” x 4” Bolt (78).
48
35
72
78
9
38