weber GENESIS 1500 LX - Manual (Page 17)

17
Your Weber Gas Barbecue burner assembly has been
factory assembled, pressure and flame tested. As a safety
precaution we recommend you check the burner alignment:
a) Are the ends of the burners under the washers at the
left rear and left front of the cooking box? The screws
are only guides. Do not tighten. Figure 15 (a).
b) Are the wing nuts under the burner assembly hand
tight? Do not tighten with pliers. Figure 15 (b).
If you answered YES to a and b, the burners are
correctly aligned. If you answered NO, the burners are
misaligned. Contact Weber-Stephen Customer Service.
Do not use barbecue.
Guide screw
(a)
(b)
Wing nuts
Spacer bracket
Keps nut
Nylon washer
Bolt
Frame cross
piece
View from
behind
cooking
box
Figure 15
Figure 13
Step 7
Add cooking box
You will need: frame assembly, cooking box assembly,
spacer bracket, 1/4-20 x 2 inch bolt, nylon washer,
1/4-20 keps nut, pliers and a 7/16 inch wrench.
Set the cooking box in the frame so the burner tubes are
under the frame brace. Figure 13.
Note: Be careful when sliding the burner tubes through
the side frame.
Burner tubes
Frame brace
Slide the cooking box to the left within the frame. Put
nylon washer on the bolt. Take the spacer bracket and
hold it up to the frame making sure both tabs fit
underneath the frame cross piece. Figure 14 (a). Insert
the bolt through the center hole in the spacer bracket,
frame and cooking box with the head of the bolt outside
the spacer bracket. Figure 14 (b). Add the keps nut.
Tighten by holding the bolt with pliers while you tighten
the nut with the 7/16 inch wrench.
Figure 14