Winegard TRAVELNET TN-2303 - Manual (Page 3)

Ver. 1.5
4/21/2009
- 3 -
Position the antennas near the cable entry point. Here the TravelNet unit was
located in the front overhead (Figure 1) with the antennas mounted close by on the
roof.
Figure 2
Note that the antenna mounts are anchored to the 7” x 7” aluminum ground plane
and that everything is well sealed.
Figure 3
3. Insert the small end of the cable through the ¾” diameter hole in the stainless
antenna mount and feed the cable through. Next screw the brass antenna mount
nut to the antenna mount as shown above, with the O-ring down, and attach the
Antennas. Locate the antenna mounts as shown, and attach the stainless Antenna