Weider 831.159390 - Manual (Page 15)

29. Note: The 3 1/2” Pulley (82) in this step is
pre-assembled. It is shown removed for
easier part identification.
Locate the High Cable (86)—this is the
shortest remaining Cable. Route the High
Cable around the 3 1/2” Pulley (82) attached
to the Top Frame (2). Be sure that the end of
the Cable with the ball is on the indicated
side of the Pulley and that the Cable is
between the Pulley and the post. Tighten
the 3/8” x 3 1/2” Bolt (66) and the 3/8” Nylon
Locknut (42), with the 3/8” Washer (38).
30. Wrap the High Cable (86) around a 3 1/2”
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the Top Frame (2) with a 3/8” x
3 1/2” Bolt (66), a 3/8” Washer (38) and a 3/8”
Nylon Jam Nut (43). Be sure that the Cable
Trap is positioned to hold the Cable in
place.
31. Locate the remaining pre-assembled pair
of Pulley Plates (31) and 3 1/2” Pulleys
(82).
Route the High Cable (86) under the indicated
3 1/2” Pulley (82). The end of the Pulley
Plates (31) with two holes should be down-
ward. Refer to the inset drawing. Be sure
that the Cable is between the Cable Trap
(80) and the Pulley, and that the Cable Trap
is positioned to hold the Cable in place.
Tighten the 3/8” x 2” Bolt (50) and the 3/8”
Nylon Locknut (not shown).
32. Wrap the High Cable (86) around a 3 1/2”
Pulley (82). Attach the Pulley to the Top
Frame (2) with a 3/8” x 2” Bolt (50) and a 3/8”
Nylon Locknut (42). The Cable must be
routed from the direction shown.
32
29
30
31
15
CABLE
ASSEMBL
Y
42
38
2
66
82
86
Post
86
80
38 66
2
82
43
86 86
80
82
50
31
End with two
holes should
be down
50
82
2
42
86