Weider 831.159390 - Manual (Page 7)

5. Slide the Front Seat Frame (8) onto the indi-
cated 5/16” x 2 1/2” Carriage Bolts (49) in the
Press Base (13). Partially tighten a 5/16”
Nylon Locknut (40) onto each Carriage Bolt.
Do not fully tighten the Nylon Locknuts.
Attach the other end of the Front Seat Frame
(8) to the Leg Press Upright (4) with two 5/16”
x 2 3/4” Bolts (55), two 5/16” Washers (20)
and two 5/16” Nylon Locknuts (40). Do not
fully tighten the Nylon Locknuts.
Press a 2” Square Inner Cap (56) into the
Front Seat Frame (8).
6. Insert two Weight Guides (23) into one of the
brackets on the Weight Base (14). Attach the
lower ends of the Weight Guides (23) to the
Weight Base with a 5/16” x 6” Bolt (67), two
1/2” x 3/4” Spacers (69) and a 5/16” Nylon
Locknut (40). Do not overtighten the Nylon
Locknut.
Attach the other Weight Guides (23) to the
Weight Base (14) in the same manner.
7. Slide a Weight Bumper (27) onto each of the
Weight Guides (23).
Slide eight Weights (90) onto each set of
Weight Guides (23). Be sure that the pin
grooves are on the indicated side of each
stack of Weights.
7
FRAME ASSEMBL
Y
55
20
49
40
56
8
40
4
13
5
90
90
Pin
Grooves
27
27
23
23
Pin
Grooves
40
69
23
23
67
14
6
7