Weider WESY19511 - Manual (Page 14)

14
26. Press a 38mm Square Inner Cap (32) into the
Seat Frame (36).
Insert the M6 x 50mm Carriage Bolt (38) into the
center hole in the Seat Plate (37). Attach the Seat
Plate to the Seat (13) with two M6 x 16mm
Screws (18).
Insert the M6 x 50mm Carriage Bolt (38) into the
indicated hole in the Seat Frame (36). Tighten an
M6 Nylon Locknut (2) with an M6 Washer (10)
onto the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with an M6 Washer (10) and the M6 x
50mm Screw (24).
27. Press a 38mmSquare Inner Cap (32) into the Leg
Lever (29).
Lubricate the M8 x 70mm Bolt (73). Attach the
Leg Lever (29) to the Seat Frame (36) with the
Bolt and an M8 Nylon Locknut (3). Do not over-
tighten the Nylon Locknut; the Leg Lever
must be able to pivot freely.
Insert two M10 Eyebolts (35) into the Leg Lever
(29) from the directions shown. Tighten an M10
Nylon Locknut (21) and an M10 Washer (9) onto
each Eyebolt.
28. Rest the Seat Frame (36) on the indicated pin in
the Front Upright (42). Attach the Seat Frame to
the Front Upright with an M8 x 67mm Carriage
Bolt (14) and the Seat Knob (40).
26
27
10
2
24
36
36
3
Lubricate
29
9
9
35
35
32
21
21
73
2
13
38
37
32
Hole
18
36
40
Pin
42
14
28