Weider WESY19511 - Manual (Page 5)

5
1
56
High Side of Bracket
3
5
51
51
14
1
27
4
1. Before beginning assembly, be sure that you
have read and understand the information in
the box above.
Press a 50mm Square Outer Cap (51) onto each
end of the Stabilizer (5). Press a 50mm Square
Inner Cap (27) into the end of the Base (4).
Insert two M8 x 67mm Carriage Bolts (14) up
through the Stabilizer (5). Insert two M8 x 63mm
Carriage Bolts (1) up through the Base (4).
Slide the indicated end of the Base (4) onto the
M8 x 67mm Carriage Bolts (14) in the Stabilizer
(5). Slide the Rear Upright (56) onto the Carriage
Bolts. Hand tighten an M8 Nylon Locknut (3) onto
each Carriage Bolt. The high side of the brack-
et on the Rear Upright must be on the side
shown. Do not tighten the Nylon Locknuts yet.
Frame Assembly
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART at the center of this
manual.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by anyone. However, it is important to
realize that the weight system has many parts
and that the assembly process will take time.
Most people find that by setting aside plenty of
time, assembly will go smoothly.
ASSEMBLY