Installation, Installation instructions, Inspection and shipping claim – Whirlpool AERO PLUS PORTABLESPA User Manual

Page 5: Unpacking

Advertising
background image

3

Installation Instructions

Inspection and Shipping Claim

Check for shipping damage upon receipt of the spa. Jacuzzi Whirlpool Bath is not responsible for damage to the

spa sustained during shipping. If damage is evident before unpacking, see instructions regarding shipping claims on
the outside of the carton and immediately file a claim with the carrier.

Once the spa has been removed from the carton and before it is permanently installed (see below on this page

for unpacking instructions), check the spa completely for damage. Fill the shell with water and operate the system
(see Operating Instructions) to check for leaks which may have resulted from shipping or handling. All Jacuzzi
Whirlpool Bath spas are factory tested for proper operation and water tight connections prior to shipping. If leaks are
detected, immediately notify your Jacuzzi Whirlpool Bath dealer or Authorized Service Agent, or call Jacuzzi Whirlpool
Bath, (800) 225-8292, for Warranty Service. (California residents, call (415) 938-7070.)

Note: Damage or defects which could have been discovered and repaired prior to installation and which are
claimed after final installation of the spa, are excluded from our warranty.

INSTALLATION

Unpacking

1. Read disclaimer for shipping damages onside of

crate.

2. Remove sides and top of crate, as well as plastic

bags, leaving pallet intact and bands securing
corrugated wrap on skirt.

3. Checkfor shipping damage.

4. Remove and set aside unattached accessory pieces.

5. Move spa to final site with pallet still attached as

shown.

4" X 4" X 72"

BLOCK

PAN

PALLET

REMOVE BOLTS

SKIRT

TOP

6. Place a 4"x4" x72" wooden block beside the pan

side of the spa so it is parallel with the pallet.

7. Tip the spa over onto its bottom with the block

supporting the spa.

8. Remove the bolts from brackets attaching the

pallet to the bottom of the pan.

9. Remove the pallet and the 4" x 4" block, then

carefully lower the spa to a horizontal position.

CAUTION: DO NOT CUT OR REMOVE
THEBANDS OR THE BOLTS THAT SECURE
THEPALLET TO THE SPA UNTIL AFTER THE
SPA HAS BEEN TIPPED OVER.

PALLET

Advertising