weber 5000 - Manual (Page 18)

18
Step 16
Install manifold bracket
You will need: manifold bracket
Hook the bracket onto the manifold at the center burner
valve. Figure 19. Place your hand underneath the
bracket. Lift the bracket, manifold and cooking box
slightly as a unit and hook onto the frame brace.
Figure 19
Frame brace
Manifold bracket
Step 17
Install brace panel
You will need: brace panel.
Slide the side burner back. Insert the tabs into the slots
in the frame brace at the wheel legs. (Make sure the
side burner hose is to the front of the barbecue.)
Figure 20 (a). Slide up until the notch at the bottom of
the brace panel fits over the cross brace. Figure 20 (b).
Slot in frame brace
Frame brace
(a)
(b)
Tabs on
brace panel
Cross brace
Figure 20
Side burner
hose
Side burner hose
Step 18
Install right end panel
You will need: right end panel (Number 3), 1/4-20 x 1 1/2
inch bolt, 1/4-20 hex nut, two nylon washers, 1/4-20 x 1/2
inch bolt, 1/4-20 wing nut and a 7/16 inch wrench.
Set the right end panel over the brace panel. Make sure
the gas supply hose is on the outside of the panel. Put
the washer on the 1/4-20 x 1 1/2 inch bolt and insert bolt
through both panels and frame brace. Add hex nut and
tighten. Figure 21.
Place a nylon washer on the 1/4-20 x 1/2 inch bolt.
Insert the bolt through the top of the right end panel and
the brace panel. Put on wing nut and tighten. Figure 22.
Figure 21
Figure 22