weber 5000 - Manual (Page 19)

19
Step 19
Install bottom accessory trays
You will need: two accessory trays
Set the two accessory trays between the two frame
connectors. Figure 23.
Figure 23
Step 20
Install igniter
Note - The igniter wires are already attached to the Gas
Catcher Ignition Chamber and the igniter. This was
done to factory test the ignition system.
The igniter lock nut is on the igniter.
Insert the top of the igniter up through the large part of
the keyhole in the frame brace. Loosen the igniter lock
nut and slide the igniter into the small part of the
keyhole. Tighten the igniter lock nut. Figure 24.
Note - If the igniter works loose, carefully tighten the
igniter lock nut with an adjustable wrench or pliers.
Figure 24
Igniter lock nut
Keyhole in
frame brace
Small part of
keyhole in
frame brace
Frame brace
Frame brace
(a)
(b)
(c)