weber 5000 - Manual (Page 26)

26
Figure 43
Hair pin cotter
Hinge pin
Step 28
Install tool holders, control panel, burner control
knobs and FlameCheck button
You will need: three tool holders, control panel, three
burner control knobs and FlameCheck button.
Hook the tool holders over the frame rail. Figure 44.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Place your thumbs over the
control panel push-in buttons and push them into the
frame brace until they snap into place. Figure 44 (a).
Push on the burner control knobs and FlameCheck
button. Figure 44 (b).
Figure 44
Hole in frame brace
Tool holders
(a)
(b)
Control panel
push-in buttons
Step 27
Install the lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair
pin cotters into the small holes in the hinge pins.
Figure 43.