Windsor TRACER FS QTFSD - Manual (Page 14)

CONTROLS
QTFSG/QTFSD 98349 05/15/03
3-6
Q – CHOKE (GAS ONLY)
By pulling this knob out, the choke is engaged for
cold starting. To release choke, push the knob in.
R – KEY SWITCH
The key switch controls starting and electrical power
for most machine functions. To start the machine,
turn the key clockwise past the “RUN” position to the
crank position. After engine has started release key.
(For starting diesel engines, see “Glow Plug Light”).
To stop engine, turn key counter-clockwise.
S – CIRCUIT BREAKERS
The circuit breakers are circuit protection devices
designed to interrupt the flow of current in the event
of an electrical overload. When tripped, the circuit
breakers must be reset by pressing the exposed
button on the face of the affected circuit breaker. If
the circuit breaker continues to trip, the cause of the
electrical overload should be found and corrected.
The following chart shows the circuit breakers and
the components they protect.
GAS:
DEVICE
RATING COMPONENT
PROTECTED
CB-1 30A Voltage Regulator
CB-2 15A Igniter, Fuel Pump,
Oil Pressure Lamp,
Water Temp. Lamp
CB-3 15A Side Broom Valve,
Head Lamps, Tail
Lamps, Horn
CB-4 15A Options
CB-5 15A Hopper Dump Door,
Shaker Motor, Hour
Meter, Hopper
Raise/Lower Valves
DIESEL:
DEVICE
RATING COMPONENT
PROTECTED
CB-1 30A Glow Plugs
CB-2 30A Starter Relay, Oil
Pressure Lamp,
Water Temp. Lamp,
Glow Plug Lamp,
Optional Charge
Light, Optional Air
Registration Light
CB-3 15A Side Broom Valve,
Head Lamps, Tail
Lamps, Horn,
CB-4 15A Options
CB-5 15A Hopper Dump Door,
Shaker Motor, Hour
Meter, Hopper
Raise/Lower Valves
T – HORN PAD
The horn pad is located on the steering wheel. The
horn is activated by pressing on any area of the horn
pad.
U – STEERING WHEEL
The steering wheel controls the two rear wheels.
The machine is highly receptive to the movement of
the wheel. Operators should use care until they
become experienced in driving the machine.
V – WET SWEEP BYPASS
By pulling this knob out, vacuum is cut off from filter
and hopper. To prevent damage to filter caused by
moisture, pull knob out when sweeping through
puddles. To maximize filter cleaning, pull knob out
before pressing filter shaker switch.