Windsor TRACER FS QTFSD - Manual (Page 30)

MAINTENANCE
QTFSG/QTFSD 98349 05/15/03
4-13
To clean the filter after removal, use one of the
following methods:
1. TAPPING Tap the filter frame gently on the
dirty side of the filter down. Be
careful not to dent the filter frame.
2. AIR Blow compressed air through the
filter opposite the direction of the
arrow on the side of the filter. This
may be done with filter in the
machine. Wear eye and dust
inhalation protection when using
compressed air.
3. WATER The filter can be soaked in water
and mild detergent. Rinse the filter
until it is clean. Air dry the filter.
NOTE: Do not install the filter until it is completely
dry.
BRAKES (Refer to the Brake Group in the Parts
section)
The brake pedal and the parking brake operate the
two front tire disc brakes. The disc brakes should be
checked every 200 hours of operation, and adjusted
if necessary. The disc brakes should be adjusted so
that the disc pads are as close to the brake disc as
possible, without causing the brakes to drag.
TO ADJUST THE BRAKES
1. Raise the hopper.
2. Engage the hopper safety arm.
Raised hopper arm may fall. Engage hopper
safety arm.
3. Turn off machine. Do not set parking brake.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, apply parking brake, turn off
machine and remove key.
4. Raise rear cover.
5. Disconnect batteries from machine.
6. Locate the brake adjustment screw on each
brake caliper.
7. Loosen the locknut and turn the adjusting screw
to adjust each brake. Tighten the locknut.
8. Lower the hopper.
9. Test brakes before beginning normal operations.
TIRES
Tires should be inspected after every 100 hours of
operation. Pneumatic tires should be inflated to 90
PSI.