Weider WESY97300 - Manual (Page 14)

26. Attach the 3 1/2” Low Pulley (88) and the 5/8”
x 9/16” Spacer (73) to the indicated hole in
the Press Frame (17) with a 3/8” x 3 3/4” Bolt
(71), and a 3/8” Washer (9). Be sure that the
3/8” x 3 3/4” Bolt (71), the 3/8” Washer
(9), the 5/8” x 9/16” Spacer (73), the 3 1/2”
Low Pulley (88), and the 3/8” Nylon
Locknut (21) are oriented as shown.
27. Locate the Low Cable (86). Slide the Low
Cable into place under the 3 1/2” Low Pulley
(88). Be sure that the end of the Cable with
the ball is on the indicated side of the
Press Frame (17) and that the Cable is
between the Pulley and the crossbar on
the Press Frame. Fully tighten a 3/8” Nylon
Locknut (21) onto the 3/8” x 3 3/4” Bolt (71).
Note: You may need to remove the 3 1/2”
Low Pulley (88) from the 3/8” x 3 3/4” Bolt
(71) to properly route the Low Cable (86).
28. Wrap the Low Cable (86) around a 3 1/2”
Pulley (15). Attach the Pulley and a Cable
Trap (66) to the lower hole in the Front
Upright (42) with a 3/8” x 3 3/4” Bolt (71), a
3/8” Washer (9), and a 3/8” Nylon Locknut
(21). Be sure that the Cable Trap is turned
to hold the Cable in place and that the
Cable is routed around the Pulley as
shown.
14
CABLE
ASSEMBL
Y
26
88
73
71
9
17
27
28
86
Crossbar
Ball
88
71
21
17
21
42
15
71
9
86
66