Weider WESY97300 - Manual (Page 7)

7
5. Set two Weight Bumpers (19) onto one of the
brackets on the Stabilizer (5). Insert two
Weight Guides (62) through the Weight
Bumpers and the bracket on the Stabilizer.
Be sure that the drilled holes in the
Weight Guides are at the top, as shown.
Press a 1” Round Cover Cap (70) onto the
bottom of each Weight Guide.
Slide eight Weights (25) onto the Weight
Guides (62). Be sure that all of the Weights
are turned so the pin grooves are on the
same side.
Assemble the other stack of Weights (25) in
the same manner.
6. Press a Weight Tube Bumper (64) into the
end of a Weight Tube (63). Insert the Weight
Tube into either stack of Weights (25). Be
sure that the pins on the Weight Tube are
resting in the pin grooves in the upper
Weight.
Lubricate the insides of the holes in a Top
Weight (76). Slide the Top Weight onto the
Weight Guides (62) and set it on the stack of
Weights (25).
Assemble the other Weight Tube (63) and
Top Weight (76) in the same manner.
6
5
FRAME
ASSEMBL
Y
25
Pin Grooves
must be on
this side
Pin Grooves
must be on
this side
19
5
70
70
64
63
Lubricate
Pins
76
62
62
25
Drilled holes
must be at
the top
25
63
76
25
62