Weider WESY97300 - Manual (Page 8)

7. Press a 2” Square Inner Cap (27) into each
end of the Top Frame (55). Press a 1 3/4”
Square Inner Cap (44) into each end of the
crossbar on the Top Frame. Press two 1”
Round Inner Caps (49) into the top of the
crossbar.
Attach the Top Frame (55) to the Front Upright
(42) and the Rear Upright (56) with four 5/16”
x 2 3/4” Bolts (11), four 5/16” Washers (8),
and four 5/16” Nylon Locknuts (3).
8. Attach the each set of the Weight Guides (62)
to the Top Frame (55) with a 5/16” x 6” Bolt
(60), two 1/2” x 3/4” Spacers (61), and a 5/16”
Nylon Locknut (3).
Tighten all Nylon Locknuts used in steps 3
through 8.
9. Press a 1” x 7/8” Plastic Bushing (75) onto
each welded spacer on the Press Frame (17).
Slide the Press Frame into place on the Front
Base (4). Note: This will be a tight fit. The
Plastic Bushings should fit onto each end
of the indicated tube in the Base. Be sure
that the indicated holes are on the side
shown.
Lubricate the 3/8” x 8” Bolt (59). Attach the
Press Frame (17) to the Front Base (4) with
the Bolt and a 3/8” Nylon Locknut (21).
8
ARM
ASSEMBL
Y
FRAME
ASSEMBL
Y
62
61
61
3
60 55
17
4
Tube
75
Welded
Spacers
Holes must be
on this side
21
3
60
62
9
Lubricate
59
7
11
8
3
27
27
42
Crossbar
49
44
44
27
27
11
8
3
55
56
8