Weider WESY97300 - Manual (Page 9)

9
10. Press a 1 3/4” Square Inner Cap (44) into the
top of a Press Arm (46). Press a 1” Round
Inner Cap (49) into the side of the Press Arm.
Attach the Press Arm to one side of the
Press Frame (17) with two 5/16” x 2 1/2”
Bolts (22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
11. Identify the Right Arm (48) and the Left Arm
(47). Note the position of the welded bracket
on each Arm. Arm identification is very
important for step 12.
Attach a “V”-Pulley (6) and a Long Cable
Trap (50) to the Right Arm (48) with a 3/8” x
2
. 1/2” Bolt (7) and a 3/8” Nylon Locknut (21).
Attach a “V”-Pulley (6) and a Long Cable
Trap (50) to the Left Arm (47) with a 3/8” x
2
. 1/2” Bolt (7) and a 3/8” Nylon Locknut (21).
12. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); refer to step
11 to identify the Right Arm. Be sure that
the upper end of the Right Arm is behind
the indicated bracket on the Top Frame
(55).
Tap two 1” Retainers (69) and a 1” Round
Cover Cap (70) onto the right axle. Be sure
that the teeth on the Retainers bend
toward the Cover Cap, as shown in the
inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47,
48). Wet the lower end of each Arm with
soapy water. Slide a 10” Pad (45) onto the
lower end of each Arm.
12
ARM
ASSEMBL
Y
Axle
47
48
45
45
44
69
69
70
70
Bracket
Lubricate
Axle
55
10
11
44
44
49
46
46
22
3
50
Welded
Brackets
21
48
47
17
49
7
6
50