Worth Data 5000 - Manual (Page 31)

30
Using the Hardware Utilities to change Setup Parameters
If you are using the FULL SPEED USB interface, you can use the Integrated Hardware Utilities program to change your setup
parameters. To use the Hardware Utilities, you must make sure your TriCoder is turned on, plugged into the computer with a C22
USB cable, and it is set for Full Speed USB interface. In the Hardware Utilities program, choose TriCoder Manager from the left
menu, and then click on the Setup button in the middle.
You will then see a screen offering the Setup options as shown below. Click on any of the tabs to change settings for that section.
Once you have made your changes, click Update and then Done and the changes are automatically made in your TriCoder.